VERSA-LOK Homepage
VERSA-TECH installation training
Build walls, steps, and columns with VERSA-LOK Weathered Standard retaining walls.

 



VERSA-LIFTER®:

The VERSA-Lifter is used to lift and place VERSA-LOK retaining wall unitsT
he VERSA-Lifter makes it easier to lift and place units, especially on the base course. The two prongs on the lifter are placed into the holes in the VERSA-LOK unit. The action of lifting the handle secures the lifter to the unit and makes for easy, balanced lifting and placement. VERSA-Lifter are available from your local supplier.

 




SQUARE FOOT INSTALLATION IS A SNAP WITH NEW VERSA-LIFTER:

The VERSA-Lifter is used to lift and place VERSA-LOK retaining wall unitsInstalling VERSA-LOK Square Foot retaining walls just got easier with the new Square Foot VERSA-Lifter. Now, your crews can lay a lot more block in a lot less time with less strain using a simple tool that has proven itself with VERSA-LOK’s Standard SRW system.

The design of the Square Foot VERSA-Lifter works on the same principle as the original model. Prongs on either end of the lifter are placed in the retaining wall unit’s end holes and as the hinged bar is lifted, the prongs grip the holes and the weight of the block secures its hold. The two-handed carrying handle has a comfortable rubber sleeve and is positioned to balance the unit evenly for maximum ease in carrying. Eighty-seven pounds will never feel lighter!

The Square Foot VERSA-Lifter facilitates easier placement of retaining-wall units, especially on the base course where accurate positioning is critical. And with a durable, bright red, powder-coated finish, you’ll never misplace it on the job site.

The Square Foot VERSA-Lifter is available wherever VERSA-LOK Retaining Wall Systems are sold.



VERSA-LOK® Fabric:
VERSA-LOK Fabric soil reinforcement
VERSA-LOK Fabric is ideal for soil reinforcement of shorter walls. This geotextile is both cost-effective and easy to install. It is available in convenient, ready-to-use roll sizes.

 




VERSA-Grid®:

VERSA-Grid
Building a wall taller than four feet or with special requirements? You're going to need VERSA-Grid. It aids soil reinforcement and helps wall stability. Its high tenacity, multifilament polyester yarns are resistant to natural chemicals, alkalis and acids so once you put it down, it won't degrade. And installing VERSA-Grid is easy, too. Just unroll flat and make sure the VERSA-Grid is perpendicular to the wall face.

 



VERSA-LOK Concrete adhesive
 VERSA-LOK® Concrete Adhesive:

A single-component, non-sag elastomer, VERSA-LOK Concrete Adhesive is designed for use in non-traffic bearing joints, including those where structural movement or stress is expected. Each VERSA-LOK Concrete Adhesive cartridge contains enough adhesive to cap approximately 14 lineal feet of wall.




 Versa-Tuff pinsVERSA-TUFF® Pins

Non-corrosive, nylon/fiberglass VERSA-TUFF Pins provide consistent alignment in standard VERSA-LOK Retaining Wall Systems. VERSA-TUFF Snap-off Pins are used for Accent, Cobble and Mosaic Retaining Wall Systems.



CO-OP ADVERTISING | PRODUCT DESCRIPTIONS | VERSA-TECH | INSTALLATION TRAINING
ACCESSORIES | WHERE TO BUY | LITERATURE | GALLERY

ABOUT US
| WHAT ARE SRWS? | WHAT'S NEW | FOR THE MEDIA
CONTACT | LINKS | SITE MAP
ARCHITECT/ENGINEER | CONTRACTOR | HOMEOWNER
HOME